Loading optional tray 3
Loading optional tray 3
| 1. | Pull the tray out of the printer and remove any media.
|
| 2. | Raise the output bin extension.
|
| 3. | Adjust the length guide until the arrow points to the size that you are loading.
|
| 4. | Adjust the side width guides until the arrow on the right width guide points to the size that you are loading.
|
| 5. | Load the media into the tray. If you are printing on special media such as labels or letterhead, see Loading special media for complete information about how to orient the media and configure the printer.
|
| 6. | Make sure that the stack of media is flat in the tray at all four corners, and keep it below the height tabs.
|
| 7. | Slide the tray back into the printer.
|
